I brought this bike four years from an owner that had it for 32 years.
This bike is in good condition. When the bike was last used two years ago, it ran really well. I have been so busy that I have not taken it out for a drive. There might need to be a check up to get it running at its potential. I am not an expert at this type of motorbike.This beautiful bike needs an owner who will appreciate it. Please take your time to look through the many pictures that I have posted. The bike does not have matching number. For further questions, contact me through email.Used 1951 Indian Chief 1,700 miles
Similar Cars
UP FOR SALE IS MY 1974 VR880 NORTON COMMANDO THAT IS ALL ORIGINAL AND IN OUTSTANDING CONDITION WITH ONLY 1138.5 MILES.
THE BIKE SHOULD BE IN A MUSEUM OR WITH A SERIOUS COLLECTOR. THANKS AND GOD BLESS.
Used 1974 1,139 miles
Here is a rare piece that we have listed a rare 1960 Harley Topper Scooter with a title.
Most people don't even know that Harley made a scooter. This particular scooter is in excellent condition. Here is some information: Toppers were made in Milwaukee Wisconsin between 1960 and 1965. There were approximately 6000 made. Scooters made after the
midway point of 1960 had a lot of changes from the Toppers made early on in 1960. This Topper is one of the rare ones made in early 1960. The later Toppers had a longer crank shaft, a wet clutch, key switch on the handle bars, a bigger carburetor, and decals instead of badges.
This particular Topper was purchased from a gentleman in Kansas that had started the restoration. He basically had torn it completely down and was in the process of reassembly. He got as far as assembling the engine, but everything else was in pieces. During the restoration, the gentleman went through a divorce and his ex-wife did something with the box containing the clutch guard, clutch flange belt, and a lot
of small parts. I never run her since the rebuild so there are no miles on this scooter since the rebuild. This is a show quality restoration on a rare scooter. The only flaw that I am aware of is there is a small chip on the corner of the cover on the right side next to the gas pedal.
It is shown in the photos.
Used 1960
Motorcycle Trailer.
Lightweight but can Haul a Touring Bike I started with a new Kendon Stand-up Trailer ($2,300). It was way too narrow for a rider to put his feet down as he rides a bike onto the trailer. And it came with 3-piece heavy steel ramps that were also too narrow (for the same reason) and too steep. (photos of the original trailer
are the last pics). So I fabricated aluminum deck plate and mounted it to the trailer with aluminum square tubing and stainless bolts and lock nuts ($240). Then I purchased an aluminum 6' ramp ($200) and built wooden side ramps ($60) for the rider's feet as the rider rides onto the trailer.
I extended the tongue and electrical wiring ($100) 4' to make backing the trailer easier. I also added a trailer jack ($40) and lock-nuts ($20) for the chrome rims. The trailer has LED lights. I will include safety-snap tie-downs. As you can see in the pics, the back half of the trailer folds up onto the front half. Pretty neat! This trailer weighs approx 350 lbs - you can't even notice it behind your
vehicle! I towed the trailer one time - to and from Galveston from Austin... fewer than 500 miles. The trailer has always been garage kept but I need the space in my garage so selling my neat little trailer!
My total costs: Over $3,000 plus many hours of labor. I will sell this practically new trailer for $2,800. Nathan
Used 500 miles
2021 Yamaha TW200. HAS RACK AND BRUSH GUARDS ON HANDLEBARS
Used 2021 Yamaha Dual Purpose 5,187 miles, Gray